Beechwood Chip Posted October 27 Report Posted October 27 I must be missing something obvious. This should be a simple, straightforward operation and I just can't figure it out! I want to route a 1/2" recess using a template. My template is 1/2" thick. So, I figure I'll use a plunge router, set the depth stop at 1/2", and make multiple passes until I hit my stop. The first passes index off the template, and deeper passes index off the earlier passes. That's the whole point of a plunge router, right? Here's the Whiteside bit I'm using Here's the bit in my router. I dropped it in all the way and then lifted it up a hair, because someone on YouTube told me to. Here's the whole thing in the plunge base, plunged all the way down. Notice that the rubber sleeves are scrunched all the way down - it's not going any further. That only gives me about 1/2" of total depth. I need twice that. I could pull the bit 1/2" out of the router, but that doesn't seem safe. I've already had problems with router bits slipping (cursed be the name of Triton) so I don't want to cut corners. The only other thing I can think of is to use a thicker template and a longer router bit. But I don't want more cutting, I just want a longer shaft. Am I missing something? 2 Quote
Popular Post Ron Swanson Jr. Posted October 28 Popular Post Report Posted October 28 No you're not missing anything. That's a pretty small bit and that's it's max depth. Plunge routers aren't really designed to plunge deep. It's the length of the bit that will ultimately determine your depth. The plunge action just allows you to begin your cut in the middle of a work piece. 4 Quote
pkinneb Posted October 28 Report Posted October 28 I agree with Doug on this. It appears you could pull the bit out some but I don't think you can pull it out enough to get what you are looking for and as you mentioned if you are having bit retention issues not the best idea. 1 Quote
Popular Post wtnhighlander Posted October 28 Popular Post Report Posted October 28 Take the collet nut out of the machine and insert the bit shank through the collet until the end is flush in back. You can pull the bit out that far and still have full contact with the collet. If that isn't enough, you might get a smidge more depth by swapping the thick baseplate for a thin piece of hardboard / masonite, or even sheet metal. It just provides a smooth surface to glide over edges in this case. I was going to suggest the motor might go farther into the base, but it looks bottomed out 4 1 Quote
Popular Post Beechwood Chip Posted October 28 Author Popular Post Report Posted October 28 Bingo! The collet trick and reducing the baseplate thickness gave me the depth I needed. Thanks! 6 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.