baok Posted November 19, 2011 Report Posted November 19, 2011 Several years ago I bought a Record low angle block plane. Other than sharpening the iron, I never did anything to it. Wow - it sucks. I've been trying to plane the end grain of some pine and the thing chatters very heavily. I even wet the grain with mineral spirits. It did this right after a sharpening. So I guess I need to start over and go through the tune-up process? I wouldn't have thought it would perform this badly. So... off to tune up I guess. Oh, and I can't find my shooting board. Can't imagine where it went. Perhaps I'll build another. Quote
duckkisser Posted November 19, 2011 Report Posted November 19, 2011 i hang all my jigs on one wall and all my patterns on another that way i can find what i need at a momenent grace but then again our classroom is 3000 square feet so we have lots of floor and wall space. Quote
kaybee Posted November 19, 2011 Report Posted November 19, 2011 I have the same plane. It's worked fine for me. That is until my husband used it to plane the decking and deck screws even with the rest of the deck. (Really.) Its just never really recovered from that. Quote
Jonathryn Posted November 20, 2011 Report Posted November 20, 2011 That is until my husband used it to plane the decking and deck screws even with the rest of the deck. (Really.) Its just never really recovered from that. Ooooh. Have pictures? I'd be curious to see. When you've got deep nicks in the iron you've just got to grind past them and sharpen anew. Then it should work fine. I've got an old Stanley No. 80 scraper with deep gouges in the sole from nail heads, but it still works well. Just call them "corrugations." Quote
Darnell Hagen Posted November 20, 2011 Report Posted November 20, 2011 I've got a bad Record LA block, too. The irons bed is at an angle to the sole. Quote
baok Posted November 21, 2011 Author Report Posted November 21, 2011 Well, I had a close look at this plane. The sole is not flat - it has a slight crown in the middle near the mouth. I did resharpen the iron and it works better. But I didn't get it as sharp as it should be - more on that in a separate post. I did not look at how the iron meets the bed. I've heard that you also need to sand off the area where the cap iron (or whatever that is that holds down the iron) meets the iron itself. So I'll put that little project on my list. Quote
duckkisser Posted November 21, 2011 Report Posted November 21, 2011 got a couple that i found and have been fearing to take on sharpening it since i am a beginner and am not very good at sharpening. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.