Recommended Posts

Posted

I have a few nice handplanes, and I sharpen the irons frequently (before every major project). I use a 4000x microbevel, and my veritas #4 is at 30 degrees primary bevel, and my old Bailey#5 at 25 degrees primary bevel. Both planes are square, and the iron cap is set about 1/32nd off the edge of the balde. Both, of course, operate bevel down.

Anyway, I keep getting "track marks" on my boards when face planing, and it's driving me insane. I have rounded the corners of the iron, and have cambered/crowned the blade (about 1/64"). I use the MKII honing guide, and the camber wheel. I also take very thin shavings (can pretty much read through them). I can't figure out why I still get track marks.

I have no problems planing material that is less than the full width of the plane iron.

I'll snap a few photos of the board, and the iron's camber and add to the post. The test boards I am using are yellow pine, poplar, walnut, and maple.

Any ideas?

Posted

The only other thing to check is to make sure the iron is centered and not cutting at the edges. Turn your plane upside down and run a small piece of wood over opening where the corners of the blade are. If the wood is catching, then you will get those plane tracks. Try using the lateral adjuster until it doesn't cut at the corners and/or back the plane iron up for an even thinner shaving until you get no catching at the corners. A cambered iron will still leave a slightly scalloped surface.

I wouldn't setup a 5 as a smoother. Leave the 4 for that. If the 5 leaves tracks it's ok, because they will get cleaned up later.

  • Like 1
Posted

Are you sure they are track marks and not micro fractures in the cutting edge? Even if they are not visible they can also leave lines that look like track marks. When I think I'm getting track marks and can't figure out why. Then I go back to my 1k stone and make sure I work it long enough to be abosultely certain I have a fresh cutting edge. More often than not this fixes the problem, showing me that I wasn't actually getting "track marks", but rather had some chipping in the cutting edge that I was not able to see.

  • Like 1
Posted

I had this problem not too long ago. It drove me nuts, I resharpen my by blade multiple times. I even reground the blade, and I still had plane tracks. Then I just happened to feel the front edge of my plane, and felt a small nick. It wasn't big, but big enough to leave a track mark. I lightly filed the edge, and presto no more track marks! So, check the edges of your plane for nicks.

Mike

  • Like 1
Posted

The only other thing to check is to make sure the iron is centered and not cutting at the edges. Turn your plane upside down and run a small piece of wood over opening where the corners of the blade are. If the wood is catching, then you will get those plane tracks.

Great tip - I'll try this. Thanks!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.