kbrunco Posted August 3, 2012 Report Posted August 3, 2012 Hey, I want to make a shooting board, but do not have a shoulder plane. Does anyone know of some nifty tricks to true it up? Is it possible to accomplish this with block and or Jack planes? Quin Quote
mlingenfelter Posted August 3, 2012 Report Posted August 3, 2012 Here's a nice link that shows just about everything you need to know about making your own shooting board. You can use just about any plane on a shoot board, but I've never tried a shoulder plane. Generally you want a plane with a wider blade, than you get with a shoulder plane. http://www.inthewood...ing Board4.html Mike Quote
RenaissanceWW Posted August 3, 2012 Report Posted August 3, 2012 Not sure I follow what you are trying to do? What are you "truing up" and what would you do with the shoulder plane if you had it? Quote
kbrunco Posted August 3, 2012 Author Report Posted August 3, 2012 I am trying to true up the shooting board. All the videos I have seen so far show that the shooting board is squared up with a shoulder plane. Quote
ExCrusader Posted August 3, 2012 Report Posted August 3, 2012 If you make a shooting board with two bolts through the fence for micro-adjust similar to what Derek Cohen built and was linked upthread, you won't need a shoulder plane to true it up. You simply square your pieces up before they are attached to each other and then adjust the fence with a good square and tighten the micro-adjust bolt. It is only with fixed-fence shooting boards that you need to true them up, and even then you could use thin material to shim the piece you are shooting (paper, cardstock, etc.). Quote
nateswoodworks Posted August 5, 2012 Report Posted August 5, 2012 All I do when I make my shooting boards, and I have made many, is apply glue to the fence, use a known accurate square to position it on the jig, and weigh it down for an hour and then drive a couple screws in from the bottom for added strength. As long as you double check with the square after weighing it down before you walk away your jig should be dead accurate. Hope this helps. Nate Quote
Paul B Posted August 12, 2012 Report Posted August 12, 2012 I glued some l scraps of veneer to correct mine and it's working fine. I didn't worry about making it true along the entire width of the fence. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.