wdwerker Posted October 29, 2012 Report Posted October 29, 2012 Any advice on rehabbing it? Looks like it has had a rough life. Lots of dings and burrs on the corners. Need to regrind the bevel, it is curved outwards and crooked. The handle is short and flat on top to take mallet blows. Small crack but I am willing to live with that. Just want to make it a functional tool. Quote
TRBaker Posted October 30, 2012 Report Posted October 30, 2012 Steve, can you post a pic so we can see what you are talking about? Quote
jHop Posted October 30, 2012 Report Posted October 30, 2012 I would wrap some leather or latigo lace around the stock to keep the crack from getting worse. Beyond that, I've got no experience rehabbing anything into something useful Quote
wdwerker Posted October 31, 2012 Author Report Posted October 31, 2012 Hard to post pictures from an IPad . I was mostly asking for input from folks who have hand morticing chisels. What angle to grind the tip and how to smooth the shank. I have an older Tormek to grind and sharpen it with. Quote
Mister Pants Posted October 31, 2012 Report Posted October 31, 2012 35 degrees for the bevel I believe is standard for mortising hard woods, Not sure what you mean by smooth the shank though. Do you mean flattening it? For flattening it'd be the same lapping process as normal (just longer, possibly much longer depending on the shape it's in ) Quote
wdwerker Posted October 31, 2012 Author Report Posted October 31, 2012 Yes , flattening the sides. It has damage to all 4 corners. I am thinking of using a file before lapping the sides. Might use some wet abrasive and a glass plate to lap. Quote
jHop Posted October 31, 2012 Report Posted October 31, 2012 If you have a flat tool rest for the Tormek, I'd start there. You can avoid the hollow ground by going carefully slow, maybe painfully slow. Basically, it's a point-by-point process. It's a "just kiss the metal to remove the high spots" process - a jig might help here. Then, go to the glass and wet sandpaper to smooth out the remaining ridges. If you've ever used Scary Sharp as a process, you know roughly how long it will take. (Again, this is all theory for me.) Quote
nateswoodworks Posted November 3, 2012 Report Posted November 3, 2012 Sandpaper on a flat surface is going to be your best bet for lapping the sides. Since the steel of the chisel is temped I think you will find that sandpaper on a flat surface will provide better results then using a file. As for the sharpening angle, mine are 25 degrees plus a couple for the micro. Enjoy the new chisel! Quote
EricFortin Posted November 3, 2012 Report Posted November 3, 2012 Might want to go a little steeper on the bevel angle for a morticing chisel. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.