Recommended Posts

Posted

I recently acquired my great-great grandfathers Stanley #7. When I got it home and got it apart I discovered that the rivet that holds the lateral adjustment lever on has pulled through. As in completely through I can easily lift the lever right off the frog. So to fix it I can think of two solutions...First re-peen the rivet with a hammer and punch. Second, have a machinist friend remove the old rivet and put in a new one. Anybody have any other ideas or thoughts on these two?

Posted

I have recently tune-up my Stanley #2 and a #604 Bedrock and I removed the lateral lever to make sure the top of the frog was flat. I use some O-1 drill rod and peened one side of it put so it would not pull through the lever and put it through the frog and peened the other end.

It worked out great and tightened up the lateral lever which was on the loose side to begin with. If you take this route be very careful with the frog, one good miss can break the cast iron. Also, the O-1 drill rod is on the hard side so it is a bit tough to peen over, so if you use some cold rolled or hot rolled steel rod it might be easier to peen over.

Posted

I always file off the rivet on the bottom so I can remove the adjustment lever allowing me to flatten the face of the frog. After doing my first one many years back I was excited to try out the plane and had always planned on getting a new rivet but never did, it has never caused a problem. That being said, all of my planes are now like this. Yeah if you take the blade and chipbreaker out and wiggle back and forth while pulling up it will come out but i never do that while planing! If I were you, unless the lever if real loose I would leave it.

  • 2 weeks later...
Posted

I've rehabbed dozens of bench planes, and sometimes less is more. Early on, I cracked a frog trying such a repair. I'd just leave it, it won't go anywhere. Actually, I don't use lateral levers, I'm a tapper.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.