Recommended Posts

Posted

I'm just curious how all of you maintain the surfaces of your tools and equipment? What products do you use, how often do you perform maintenance on them? Not talking about calibration or alignment, just lubrication (where applicable) and maintenance of surfaces. Thanks!

Posted

I use Bostick TopCote on my tablesaw before I every big project , paste wax on joiner and any other cast iron. Bostic recently changed the name and packaging of TopCote and Dricote( for blades and bits)

The DriCote really does help reduce the buildup of resin on saw blades and router bits. Every time we change a blade or bit it gets a quick cleaning with CMT blade cleaner( or whatever brand was available ) and a stiff bristled plastic brush. Blow it dry with compressed air, go back if I missed any spots of resin, then a quick spritz of DriCote before being stored. I pulled out a router bit yesterday that is at least 20 years old, it was spotlessly clean and has never been sharpened. Resin builds up and causes heat which dulls tools, so keep them clean and lubed!

Posted

I use the air compressor to blow out the motors on all my power tools after any long woodworking sessions (post big projects and the like) . I try to keep the mostors and bearings as dust/dirt free as I can.

As Chip stated, paste wax on the table saw top, drill press table, band saw table. Learned that one from my GrandPa decades ago.  

On Items that need lube I use good quality dry lubes as thay attract and hold far less dust and dirt (I was/am a bicycle mechanic also, so most of my lubes are dry chain lubes, White Lightning, Boshield T-9, Spin Doctor, ProLink, Perdo's Dry, etc..)

I keep all tools stored in their original supplied cases, in cabinets, to protect them when not in use.

I sharpen edgeds as needed and before any projects. I use an oil stone and leave a bit of oil on the honed edge when they get stored after use to prevent rust.

I keep a few large silica gel packs in tool drawres to keep moisture issues to a minimum.  

Posted

Johnson's Paste Wax as needed on cast iron.  Usually when I feel there is too much friction on the cast iron table.  I will occasionally clean out the motors, and such, with a vac, but probably not as often as I should.

 

Keep wax on my hand tools to keep them from rusting too.

 

chris

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 45 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined