Recommended Posts

Posted

I am using some Matsumura Blue Steel Dove tail Chisels for cleaning up my dovetails. Today I cas cutting waste in some oak and I noticed the edge was nicked up. I cleaned up the edge and resharpened it. After cleaning out another 2-3 notches I noticed the edge was already nicked again. I am sharpening at 25 degree using the Veritas guide and then adding a micro bevel. Should I be sharpening at a different angle or did I possibly get a soft chisel? Thanks in advance for any advice.

  •  
Posted

change the bevel to a steeper degree

 

try it without the double bevel

 

then you can dicide if its soft steel by taking a hard steel that you know is hard and see if it scratches easily or not.

  • Like 1
Posted

Some japanese chisels have a piece of hard quality steel laminated to a softer steel body. If the chisel is old or has been frequently sharpened you could be past the hard steel and trying to sharpen the soft steel body. Take a close look at the side of another size chisel and look for the fine seam between the layers for the first inch or so of chisel .

Posted

Thanks for the advice guys, the chisels are new so I shouldn't be anywhere near the wrought iron yet. I eliminated the secondary bevel and will give that a try. If that still nicks then I will go on up to 30.

Posted

I set up my Japanese chisels at 30° for general use. I'll use 25° for my Jaoanese chisels that are reserved for paring. And I have a couple of Japanese mortise chisels that have a 35° bevel.

Don't use secondary bevels on Japanese chisels. The laminated construction of your Matsumuras will benefit most with a flat bevel.

One other thing: if your chisels are relatively new, the very edge might be over hardened a little, which will lead to chipping. Sometimes once you get past the initial 1/16" of a new chisel, it becomes much better behaved in terms of chipping.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 52 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined