nateswoodworks Posted March 31, 2013 Report Posted March 31, 2013 I don't know about you guys but everywhere I turn I see Irwin, and now handplanes too! I was looking on ebeay for a jointer plane and came across these, i have never seen them in person so I haven't idea the quality but would suspect entery level. http://www.irwin.com.au/tools/chisels-hand-planes/irwin-record-bench-planes By the way I think I am just going to go new on the plane, a few years ago when I flattened my fore plane it took me long enough and this one is quite a bit longe! I have restored many planes but this time I am going to take easy road:) Quote
G S Haydon Posted March 31, 2013 Report Posted March 31, 2013 Hi Nateswoodworks Firstly I am far from the leading authority on planes but this is what I found. I bought a smoothing plane like this a while ago and it looked just like yours (since then I bought a vintage record). I'm not sure why the lever cap has a screw instead of a lever, I can only assume cost. I can't see a massive drawback with a screw apart from taking a little longer to release. The worst part of the plane was the blade and chip breaker. They are both very very thin (irwin might be better). When you do up the screw on the chip breaker it soon bends the blade. However a two piece chip breaker would prevent the bending as they don't apply bending forces to the blade like a normal chip breaker does. I would avoid trying to retro fit thick blades and thick solid chip breaker. I have tried it on an old record plane and the y lever did not engage properly and it looked like it would wear fast. If you can go to a store and take one out the box and hold it on a flat surface to make sure the sole is flat that's going to be a bonus(really critical on a jointer). If it's not flat you will spend so much flattening it you would of been better off going for a better brand. However if your jointer plane is only getting occasional use and you purchase a two piece chip breaker then I don't see a problem. I would not be ashamed to have one like this in my tool box as long as it did the job well, I like nice tools but how they work is the important bit for me. I look forward to hear what other people have found with these budget planes. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.