Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Leaving finish in sprayer in between coats.

Featured Replies

I do it all the time. I just usually have to scrape dried finish off the tip of the gun. But everything inside the gun is sealed by the Lid of the gun, and the tip of the gun.

Just make sure between coats to soak the air cap in thinner, water-based I like denatured alcohol or lacquer thinner. The other's use the appropriate thinners. Keep that air cap tip top clean.

 

-Ace-

==> Just don't leave it overnight with a post-cat.   :rolleyes:

 

yea, no kidding...  I've done lot's of dumb things, but not that one.... yet...  I once dropped a gun into a 5gal bucket of paint -- now that was fun...  and it wasn't connected to a hose, of course...

One thing I'd recommend and expand on what was already mentioned would be to take some solvent (appropriate to the material you're spraying), dip a toothbrush in it and scrub the tip of the gun (needle tip and the air ports that atomize the finish).  At the end of the day I always do a full break down, flush the lines if you're using a pressure pot and clean everything, but I have been known to be a little anal.. 

 

Yes, I said it.. And after a couple Bombays I might actually admit it! :P

  • Author

Well I sprayed between coats and the tip got a little gummed up but was able to clean it and and get it to work. when I was done I just used soap and water and ran it through the gun, then fresh water rinse. I probably should have brushed the tip. 

Well I sprayed between coats and the tip got a little gummed up but was able to clean it and and get it to work. when I was done I just used soap and water and ran it through the gun, then fresh water rinse. I probably should have brushed the tip. 

 

Obviously, you're using a waterborne finish. I just pick the dried crud off the aircap after spraying and wrap a wet rag around the front of the gun between coats.

 

A tip: after the clean water rinse, run an ounce or so of DNA through the gun, helps dry things out.

 

Best,

Bill

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Who's Online (See full list)

  • There are no registered users currently online

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.