TheFatBaron Posted August 9, 2013 Report Posted August 9, 2013 I finally finished my new tortilla press. The design is pretty basic... I just decided to make my life difficult and do wedged stepped/haunched/whatever tenons for joinery. The body is 6/4 honey locust (rescued from a scrap/cutoff bin), the handle and presser bar are hickory, and the wedges are jatoba. Epoxy (mixed with sawdust/dye) was used to stabilize the knot. The finish is GF Salad Bowl Finish, sanded up to 1200 grit. Originally I was going to try scraping the surfaces, but the grain is so difficult, I found it far more reliable to just sand it down. Overall, I'm happy with it, but I definitely made a couple mistakes. The wedged side of the tenons are pretty gappy on the first set (the second set I cut is better). Some of the mortices are too close to the edge, so I had to make some repairs when pieces broke off. And my drill bit broke when halfway through making pilot holes for the hinges, so I had to fudge a workaround, and now the two pieces are slightly crooked. Still... it sure is pretty. 1 Quote
rodger. Posted August 9, 2013 Report Posted August 9, 2013 Forgive my ignorance, but how is a tortilla press used? Is it for flattening dough prior to baking the tortilla? Quote
TheFatBaron Posted August 9, 2013 Author Report Posted August 9, 2013 Yep. Basically, you open it up, put a ball of dough in, close it, and press. The hinge setup gets you a lot of leverage - more than, say, a heavy skillet, so you get a nice, thin tortilla that you can then cook. Quote
..Kev Posted August 10, 2013 Report Posted August 10, 2013 We used something similar for Hamburger patties. They work great! Nice job on the press! Quote
mkirby Posted August 10, 2013 Report Posted August 10, 2013 Make it bigger and you can do pizza's to with Marc's pizza peel. I like it i might have to give it a go alongside a small apple press i have been asked to have a go at. Quote
Vic Posted August 10, 2013 Report Posted August 10, 2013 Funny how the collective mind works. I'm in the process of designing a tortilla press at my wife's request. I got my start from my buddy Nik Brown's site: http://digitalwoodworker.com/2012/07/13/diy-tortilla-press/ Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.