bobcrosley Posted December 24, 2013 Report Posted December 24, 2013 With a combination of work travel and some other stuff that consumed 110% of any available time, this is where I find myself today... 1 Quote
Popular Post wdwerker Posted December 24, 2013 Popular Post Report Posted December 24, 2013 For last minute finishing I use as much heat in the area as possible, very thin coats and each time you coat do a scrap piece last. Test for dryness and ability to sand on the scrap to keep fingerprints off your project. Rattle cans or flammable finishes should dry the quickest. I use a turbine HVLP and letting it run for 10 minutes before you spray gives you warmer air which helps. I use waterbourne finishes and generous air flow helps. Not too direct just blowing in the general direction over the work. Thin coats and scuff between with a grey abrasive pad works for me. Maybe a bit thicker final coat. Oils, varnishes and wipe on finishes would be my last choice. 3 Quote
Eric. Posted December 24, 2013 Report Posted December 24, 2013 This is why Mother Nature invented the lac bug. Use their spit. Have a good time. Quote
Trip Posted December 24, 2013 Report Posted December 24, 2013 ==>^^^ Yea, no s*it... Shooting #1.5ct is on my agenda for this afternoon... Quote
Tpt life Posted December 24, 2013 Report Posted December 24, 2013 Just beware the rattle can shellac. That alcohol odor can persist for a day of two in end grain Quote
Popular Post Eric. Posted December 24, 2013 Popular Post Report Posted December 24, 2013 Just beware the rattle can shellac. That alcohol odor can persist for a day of two in end grain If things go right today, I won't be able to smell alcohol on anything but myself by about 2PM. 4 Quote
Tpt life Posted December 24, 2013 Report Posted December 24, 2013 Ah the life of a musician. I gig at a church at ten PM tonight, y'all enjoy last minute projects.... Quote
TerryMcK Posted December 24, 2013 Report Posted December 24, 2013 I just finished a project that is a present for my wife for tomorrow. I finished it today 24th Dec at 4PM. It's a jewellery box or cabinet that is finished with GF Enduro-Var. The last coat was applied last night. I know it will take a few days to harden off completely but it is hard enough at the moment. Talk about last minute though! Quote
bobcrosley Posted December 26, 2013 Author Report Posted December 26, 2013 Not bad Terry. I sanded the last coat on the last project at 9:30pm on December 24. The two I finished yesterday are gifts staying at the house. They needed to be dry enough to put under the tree, but I can't easily hit them for their final sanding once the finish cures. Florida weather could not have been more perfect for spraying yesterday. 72 degrees with a light breeze and an unheard-of 25% humidity. Gorgeous day. Steve: THANKS for that advice about also spraying a scrap piece. Saved my butt on more than one occasion. That's the true wisdom that comes from experience. I don't have a spray rig, so I was spraying rattle-can poly. Water-based for a project that had some stenciled artwork on it and one with oil-based so it could match another piece. Have to say that spraying water-based poly is one of my new favorite things. An Earlex rig moved way up my tool priority list. Thanks again everyone for the advice. I'd like to say I won't let that happen again, but I know it probably will. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.