Warren Hein Posted May 21, 2014 Report Posted May 21, 2014 Building a 5 inch thick top for my bench and am in the process of setting up the tilt bracket. The bracket has an insert for the bar to go through and clamp against, but I can't seem to get enough play to allow a full 90 degrees of range. For others who have this installed, how deep does the mortise need to be, and how far from the vise itself? Any measurements would be appreciated. In my case it seems like I need to make a 4" deep mortise for the bracket, which doesn't seem right. I'm thinking of angling my mortise so that the guide bar is 90 degrees to the bracket instead so I don't have to go so deep. Sent from my iPhone using Tapatalk Quote
Warren Hein Posted May 22, 2014 Author Report Posted May 22, 2014 Solved it. I ended up making my mortise about 2" deep and then slightly angled the bottom. Everything moves nicely with no binding. However anyone looking at this for reference in the future, be sure to leave enough of a gap for the bolt on the tilt bracket so that it doesn't interfere with the base. I had to hog out a relief for the bolt and allow me to remove the top on the future. Installed and waiting for me to make a handle so I'm no longer using a plunger handle. Sent from my iPhone using Tapatalk 1 Quote
Warren Hein Posted May 22, 2014 Author Report Posted May 22, 2014 I'm looking forward to putting it into use. Here's the front install after hogging out the profile. Sent from my iPhone using Tapatalk Quote
Tom King Posted May 24, 2014 Report Posted May 24, 2014 I've been tempted to buy one for a long time, but I don't think I'm smart enough to use one. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.