Recommended Posts

Posted

Bought a used planer a few months ago and it's starting to act up. Pretty awful snipe. Leveled the infeed/outfeed, need to wax them. Cranked it up to look at the rollers, and see the damage shown in the attached photo. Am I correct in assuming I need a new roller?

post-15184-0-04859500-1402975446_thumb.j

Posted

Snipe happens when the work piece is not held flat against the bed. This usually happens because the end farthest from the cutter isn't properly supported, allowing the end under the cutter to lever up into the blades when only one of the feed rollers is holding it down. If the work is supported, I can't see that roller damage causing snipe, but it may cause slip when feeding the wood through.

Posted

I sorta solved the snipe problem with my 735, by going to HF and getting a couple of cheap rollers and building an adjustable stand for the outfeed side, and setting them a tad higher than the actual planer outfeed!   A "tad" is a very precise measurement actualized with perfect 40/40 eyesight.

  • Like 1
Posted

The pic isn't displaying it well, but I'd say that damage goes down 1/4" at its worst. What's happening is that the workpiece feeds in okay, but sort of stalls out and doesn't make it through to the other side without me pushing or pulling. It then gets chewed up by the cutterhead. I think that indicates an issue with the outfeed roller. The pic is actually of the infeed roller. I've read that these rollers are spring loaded. When i push the rollers from the bottom, there's no give, like I would expect. Should there be?

Posted

They are spring loaded, but the springs are pretty stout. You may not be able to move them by hand.

If there is 1/4" of rubber missing from tbe infeed roller, and the snipe is on the tail of your board, I'd say that 1/4" gap is enough to let the back of the board lever up into the cutter a bit. It needs to be fixed anyway.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   1 Member, 0 Anonymous, 44 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined