estesbubba Posted February 17, 2015 Report Posted February 17, 2015 With a new table saw comes some shop projects. First was the outfeed table and I just finished 3 sleds. Put shellac on the miter sled then decided it wasn't worth the trouble doing the crosscut sleds. Some paste was on the bottoms and I called it good. The crosscut sleds will handle 13" and 25" wide boards. I used the 5 cut method and got both dialed in nicely. Now it's finally on to some small real projects then I might tackle the Roubo. 2 Quote
bushwacked Posted February 17, 2015 Report Posted February 17, 2015 Loving the built in T tracks on those sleds!! Quote
wdwerker Posted February 17, 2015 Report Posted February 17, 2015 Looks quite professional ! Roubo, Roubo, Roubo..... Quote
Raefco Posted February 17, 2015 Report Posted February 17, 2015 very cool, one of these days, I may have to buy a tablesaw worthy of a sled 1 Quote
Tim Kohl Posted February 17, 2015 Report Posted February 17, 2015 Good call on the t track. Just rebuilt mine with t track and stop block. repurposed original sled to dado sled. Quote
wtnhighlander Posted February 17, 2015 Report Posted February 17, 2015 How do you feel about using runners for both table slots? I have a crosscut sled with 1 runner, and it works great. My miter sled has 2 runners, and it tends to bind with changes in humidity. Quote
estesbubba Posted February 17, 2015 Author Report Posted February 17, 2015 On my past sleds I used QS white oak and didn't have any problems. On these I used QS hard maple and hoping for the same luck. Boards were actually plain sawn and rotated 90 after cutting making QS in the slot. Quote
Countryside Workshop Posted February 17, 2015 Report Posted February 17, 2015 What t track did you use? And why two different crosscut sleds? Quote
estesbubba Posted February 17, 2015 Author Report Posted February 17, 2015 What t track did you use? And why two different crosscut sleds? I got both t-track and ruler track (and ruler) from Hartville Tool. On my last saw I had a 25" capacity sled and it's a beast to move around but nice when you need to do a 24" crosscut! I got the idea from a FWW article to make two and guessing the 13" will be used 95% of the time. That's why I added the ruler track to it and also made it a little wider for more support. It is easier to move on and off the saw plus I'll keep it right by the saw since it takes up less room. The 25" and miter sleds will live on the wall somewhere. I don't use a miter saw for woodworking and use my sleds for all crosscuts. Both are dialed in within 1/1000" square over 12" which no miter saw is going to beat. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.