Enclosed spaces Posted March 8, 2015 Report Posted March 8, 2015 Just finished the live edge maple burl and oak box. While I like the design I've had a few issue's. How are other people attaching wood hinges to their projects? Can I use just regular 2 part epoxy to fill knots and checks ( seems too thick to flow into the gaps )? The Burl wood is old and Spalted and just soaks up either Danish oil or poly. Could probably soak up a whole can of either of these. Any suggestions for an alternate finish? Quote
Rapid Roger Posted March 9, 2015 Report Posted March 9, 2015 I really like the design of your box. Very original! As for the hinges, I really don't have a valid answer. If the box was large enough to drill and screw from the inside, that is what I would do. However, being a small box builder myself, I know that is not always possible. My favorite hinge design for small boxes is what I call the "finger joint method". I've used it on a jewelry box and this smaller box. A 1/8" x 6" long drill bit and a piece of 1/8" brass rod and "Bob's your uncle"! Rog 2 Quote
johnbinva Posted March 9, 2015 Report Posted March 9, 2015 Those are outstanding, gents! Very unique and well done! Quote
Coop Posted March 9, 2015 Report Posted March 9, 2015 My experience with the two part epoxy (West Systems) is that it does seem awfully thick, but just don't damn up the back and sides and you'll find as I did, that stuff flows into every little crack. Use blue painters tape for the damn and I thick you'll find that it will fill your voids fine. Great looking box. I would like to see a couple of more pics with the lid open. Roger, Neat looking box as well. Quote
timbruno Posted March 9, 2015 Report Posted March 9, 2015 Nice boxes both of you. Don't have an opinion as to the glue, but I would think epoxy would fill Ok? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.