Tim Kohl Posted April 1, 2015 Report Posted April 1, 2015 The small boxes have been fun to make. Each one has been higher in quality than the last. Rather pleased with that. The completed one is for my daughter and the one as a project journal is for my daughter in law.I have been re-sawing stock on my table saw by cutting 1/2 way then flipping stock and placing shim in cut before cutting most of the way through. Separate halves with a hand saw.box joints are made with a home made jig. put it up before taking picture.bottom strips were quarter sawn hard maple. wanted to see if fleck showed up like in White oak. They did Quote
Tim Kohl Posted April 1, 2015 Author Report Posted April 1, 2015 adding pics hereThat's all for today wife just home Quote
wtnhighlander Posted April 2, 2015 Report Posted April 2, 2015 Nice boxes Tim! Post a pic of your joint jig, if you get the chance. I like to see different ways of making that joint. Quote
Coop Posted April 2, 2015 Report Posted April 2, 2015 Tim, Neat looking box. I like the drawer. Quote
Tim Kohl Posted April 2, 2015 Author Report Posted April 2, 2015 just made a simple box joint jig with double runners and only cuts a single size. Figured the less moving parts the better.this is the box after glue up and ready to build drawer, pulls and the top. And clean glue up.pictures a little better organized than OP :}. Quote
Coop Posted April 3, 2015 Report Posted April 3, 2015 Tim, I have a box joint jig for my router table and use different size bits for the cuts. How do you get wider cuts than your blade? Do you just move it over and nibble each one out? Quote
Tim Kohl Posted April 3, 2015 Author Report Posted April 3, 2015 cooper I just cut that one size. If I decide I need a bigger finger ill make another. I use a standard Dado stack 2 primary blades and a 32nd shim. I don't have a router table yet. my next purchase will be a 14" B.S. Quote
Tim Kohl Posted April 3, 2015 Author Report Posted April 3, 2015 Not my fist attempt at dovetail but my best effort. hopefully will be ready for finish today. Quote
Tim Kohl Posted April 12, 2015 Author Report Posted April 12, 2015 ]donefinished with amber shellac once that dried 2 coats of BLO. 1 Quote
wtnhighlander Posted April 12, 2015 Report Posted April 12, 2015 Cool box! Nice job with the drawer, too. Quote
Coop Posted April 13, 2015 Report Posted April 13, 2015 Nice looking box Tim. Good job on those dt's! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.