byegge Posted September 23, 2015 Report Posted September 23, 2015 I have an older jet contractor saw that I paid 50 bucks for on Craigslist. It is a beginner saw for a beginner. I've used it now for about 6 months with little issue until yesterday. I recently got an sd208 dado stack and had it set for 1/4 in cut to make some drawer runners for my project when I began to notice that every cut was getting progressively shallower. I ran the saw with no wood and watched the handle for raising the blade and sure enough it was backing down. I ended up clamping it with a quick clamp but needed a permanent fix. Any ideas why this is happening. Works fine with a regular blade. I will say that there is some vibration in the saw even after a adjustable v belt. Thanks Quote
wdwerker Posted September 23, 2015 Report Posted September 23, 2015 There should be a locking knob or lever for both the height and angle. Look online for the instruction manual. It should be available in a PDF file. Quote
Andy Wright Posted September 23, 2015 Report Posted September 23, 2015 I believe that on the Jet contractor saws there is a little knob in the center of the height adjustment wheel. To lock the height, you need to tighten down that knob.On my old contractor saw I didn't always have to lock the blade - for basic cuts I could just set the height use it. However, if I was making a cut where the blade height was important then I made sure to lock in the height Quote
knotscott Posted September 23, 2015 Report Posted September 23, 2015 Yep...I think even the really old Jet contractor saws have a lock knob on the front handle. Quote
byegge Posted September 23, 2015 Author Report Posted September 23, 2015 there is a knob in the middle of the wheel, but it didnt appear to work, dont want to crank down too hard on it, maybe it needs a couple washers in front of it, ill screw around with it some more tomorrow. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.