miranthis Posted December 14, 2015 Report Posted December 14, 2015 My current set up is 40 inches wide. I have a chance to increase that to 50 or 60 inch. Am I nuts?Jeff in KC Quote
Beechwood Chip Posted December 14, 2015 Report Posted December 14, 2015 Only downside to a wide table saw is space in your shop. If it won't get in your way, then go for it! Quote
Strasberry Posted December 14, 2015 Report Posted December 14, 2015 My current set up is 40 inches wide. I have a chance to increase that to 50 or 60 inch. Am I nuts?Jeff in KC No! Especially if you deal with sheet goods! Quote
knotscott Posted December 14, 2015 Report Posted December 14, 2015 My saw is 40" wide in it's stock configuration. I've added router table extension, so the whole table surface is closer to 60" wide. Not a problem if you can deal with the loss of space. If you're saw is left tilt, you might be able to slide the front rail right for more rip capacity too. Quote
miranthis Posted December 14, 2015 Author Report Posted December 14, 2015 My saw is 40" wide in it's stock configuration. I've added router table extension, so the whole table surface is closer to 60" wide. Not a problem if you can deal with the loss of space. If you're saw is left tilt, you might be able to slide the front rail right for more rip capacity too. Each section of the wings has its own part of the track for the fence, so whatever the width is, that is the rip capacity. :-) In fact, I had to move a wing a few weeks back from one side to the other to get the capacity I needed for a particularly wide rip. Adding an additional wing would solve that issue for me. Jeff in KC Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.