Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Quick Bandsaw Trunnion Fix

Featured Replies

  • Popular Post

A couple of weekends ago, I was installing my Grizzly bandsaw fence on my Jet 14" bandsaw when the table wobbled. I reached under to tighten the trunnion clamps and the trunnion came off in a handful of pieces. This bandsaw is about 15 years old and the trunnions were made as an aluminum die casting. I ran down to my local Jet dealer and ordered replacement parts, but I had a bunch of Cub Scouts coming over to work on their Pinewood Derby cars and the new trunnions wouldn't be delivered for 2 weeks. Not wanting to disappoint them, I decided to cobble up a fix.

I took a chunk of hard maple I had laying around and machined a couple of dadoes to create the ears that would bolt the trunnions onto the table. I used super glue and reconstructed the least damaged trunnion and used it to mark the holes to hold it on. I ended up with a block that looked like this:

569417434562b_TrunnionBlock1-11-16.jpg.d

After cutting it into two pieces I marked out the curves using my Rockler radius gauge set and went to cut it on the band..... oh, wait, the bandsaw is busted. Ok, so I got out a hand saw and cut the rough curve out. Then I used my disk sander to finalize the curve and the radius gauge set to check it. I drilled a hole in the middle for the trunnion clamp, added a couple of 5/16" x 3" bolts and jig knobs, bolted them to the bottom of the bandsaw table (M6-1.0 x 30mm bolts), plopped the table in place and clamped it down. A little fiddling with table leveling and I was good to go. I like the results. The table is more solid than it used to be. I thought back to when the last time I tilted the table was and came up with never, so I may leave these in.

569419448444f_BandsawTableShowingTrunnio

5694195d5d201_BandsawTableTrunnionsInsta

While I was at it, I installed the tension release I have been putting off for a couple of years. It was easier than the instructions made it look.

569419fecd9ea_BandsawTensionAdjuster.jpg

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,009 Total Members
  • 3,644 Most Online
  • Joseph b Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.