Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Using Polyurethane

Featured Replies

I have made a wooden sign out of laminated plywood that is approximately 1' X 3' and painted it with enamel. It will be mounting 1/4" thick raised letters on it. Since it will be mounted outside, I am looking for some tips on the final finish. I was thinking about polyurethane over the entire sign after I mount the letters but not sure whether to use spray, due to the raised letters, or brush on. Or maybe something else is better that will give me a nice smooth finish. Any ideas?

I would spray General Finishes Exterior 450.   if you email them they can advise on how it will adhere to the enamel, but assuming it is fully cured I think it will be fine.  

Depending on where you are going to put the sign I would probably use a spar varnish. If it is under some sort of shelter regular poly would probably be ok, but will need to be re-finished somewhat regularly. As far as application I would definitely spray. Spraying always produces a better finish for me personally. I sand with 400 grit between coats and 800 before the last coat then rub down with the gray synthetic steel wool after the last coat. Probably overkill for an outdoor sign but will produce a nice smooth finish.

Definitely a spar varnish or other outdoor-specific finish, if its used outdoors. Even under a roof, humidity swings will cause wood movement, which spar varnish is formulated to allow.

I used a spar varnish over a sign with some painted parts, and it still looks good after 2 years of full outdoor exposure.

I would finish the letters on all sides before attaching them. Spraying a clear topcoat afterwards is a good idea too. 

General has exterior clear waterbourne finishes that won't add the amber tint you get from varnishes. Double check about putting it over oil based enamel.

1 hour ago, AceHoleInOne said:

The raised letters made of wood? Dip the letters in spar to seal, then attach. 

 

-Ace-

Oops....dip letters and let dry, then attach. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.