Skip to content
View in the app

A better way to browse. Learn more.

Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

oil stain with oil poly issues

Featured Replies

I was using a dark stain on white oak. looked great then went to use general finishes satin oil poly and pulled out a lot of the stain now it looks very light. I was thinking on the next coat to put a little stain in the general finishes to try to darken it up again. bad idea, good idea? just not as happy with the finish now. 

Perhaps the stain was not completely dry. Sometimes a was coat of shellac can provide protection from the poly solvent removing the stain.

I would not suggest adding stain to the poly, unless you really don't want the wood to look like wood. Dye, maybe, but not pigment stain.

By Satin Oil poly do mean their ARM R Seal product,( ARS) ?  I never not had any problems like you describe with ARS.  I hate to say it but I think that the finish coat needs to be sanded off.  Then you can restain and really allow the stain to dry completely before finishing.  Good luck.

If you read the instructions most stains say to apply and then after a few minutes wipe it back. Lots of people leave way to much stain sitting on the surface in an attempt to get a darker result. This surface stain is easy to dissolve and even if it doesn't the finish can fail because it's only stuck to the stain, not the wood underneath.

Factory and professional finishers use dyes ,tinted finishes , spray on stains and all sorts of trickery to get those dark rich finish colors. If you strip them off there is usually not a decent wood beneath.

  • Author

I think I'm going to go with the sand and reapply option. I believe you are right i gave the stain about 20 hours to dry but should have waited longer its pretty cold right now in my shop too. My test board that i applied the stain to about 2 or 3 days ago did not pull off enough to effect the overall color. Need to be patience and looks like i wasn't this time. Thanks for the advice everyone. 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,010 Total Members
  • 3,644 Most Online
  • Lolli4 Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.