Popular Post Mark J Posted September 17, 2017 Popular Post Report Posted September 17, 2017 This is my fourth bowl and I'm rather pleased with it: So I accidentally wandered into this video.https://youtu.be/Vmz5BKXBGLA Jimmy Clewes turns an oriental box. No idea who this guy is, but he has a british accent, so I watch him take a square block of wood and turn it leaving these wings. Obviously a very skilled guy with a lot of experience. I really liked the look and it gave me an idea I wanted to try. Now I have very little experience, not much skill, and no accent, but hey I did have a square block of wood. So how many more points of commonality do you need? Here is a picture of my full size plan. The drawing is a combination of the en face side view (right) and a 45 degrees oblique view (left) which shows the wings at maximum extent: I did not want to have to carve off the unwanted corners and all that wood from the bottom half with a carbide scrapper so I made partial depth cuts with the SCM saw: Follow up partial depth cuts at 22.5 degrees: Rounded, then shaped the bowl and wings: The surface smoothed after a great deal of sanding, which was very tedious. Then the boring part: Remount and shape the inside. Then finally, with teeth clenched and fingers crossed, shape the wings: All good. Sanding redux. Finished bowl: I choose an ambrosia blank for this bowl because it was the right size and I thought ambrosia desirable. But I have to be honest I do not like the look of this wood. So in the future I won't be competing with ambrosia lovers for the limited stock available. Otherwise I am quite happy with the bowl. I expected at least one of the wings to break off during the turning. I did loose a few small chips from the wing tips (and smacked the crap out of my fingers more than a couple of times), so the droop is not as dramatic as I intended, but, on the whole not noticable after final sanding. The surface coat is bees wax in mineral spirits. 3 Quote
RichardA Posted September 17, 2017 Report Posted September 17, 2017 I like it, and it seems you did good. Interesting piece. And I can see how and why you got your fingers smacked. Quote
Eric. Posted September 17, 2017 Report Posted September 17, 2017 Looks pretty cool. Nice job. You need a bandsaw. Quote
..Kev Posted September 17, 2017 Report Posted September 17, 2017 Cool looking piece! Those spinning corners on the lathe would definitely get my pucker factor up! Nice job! Quote
Chet Posted September 17, 2017 Report Posted September 17, 2017 That came out real well especially considering it was your first try at the design. Well done. Quote
Mark J Posted September 17, 2017 Author Report Posted September 17, 2017 Well, thanks very much for the comments and compliments. I will tell you that I had no "inadvertent communication" of the turning chisels with the wings. The tips are fragile and your gonna have some loss there, but I never got wacked. Where I did get wacked was trying to sand up close to and into the wings. What I finally realized was: 1. Do the wings with the machine off, and just sand them by hand. The sanding result was much better (with the wings spinning the sanding was predominately on the leading edge and skipping the rest of the wing), and with the motor off you don't get wacked. 2. When sanding the body of the bowl, keep the speed low so that when you do go close to the wings you are in better control if you do get wacked it's much more gentle. Cutting the wings calls for high speed, but not the sanding. 2 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.