MHRestorations Posted October 30, 2018 Report Share Posted October 30, 2018 I have a 16" wide walnut board with a lot of cupping. Sending this through the planer is not an option. Wondering if ripping it down the middle, joining the edges and glueing up as a panel would be an option? This is for a shelf, and unfortunately it came out of the kiln like this when I picked it up from my supplier. Quote Link to comment Share on other sites More sharing options...
Chestnut Posted October 30, 2018 Report Share Posted October 30, 2018 That is exactly what i did for these benches can you find the seam? Quote Link to comment Share on other sites More sharing options...
MHRestorations Posted October 30, 2018 Author Report Share Posted October 30, 2018 Sure can't. That looks really good. When you ripped down the middle, was there still some cupping on each half? I believe I would still have a little left to take care of. Quote Link to comment Share on other sites More sharing options...
Coop Posted October 30, 2018 Report Share Posted October 30, 2018 I did the same to a small table top. And the narrower the piece, the less wood you loose to the jointer. Quote Link to comment Share on other sites More sharing options...
Chestnut Posted October 31, 2018 Report Share Posted October 31, 2018 4 hours ago, MHRestorations said: Sure can't. That looks really good. When you ripped down the middle, was there still some cupping on each half? I believe I would still have a little left to take care of. Yeah i did have to flatten each piece but it meant taking off 1/8" material instead of 3/4". Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.