Recommended Posts

Posted

I finally got the drill press I bought last month put together today.  Hurray!  I turned it on and there's visible run out.  Boo Hiss!

I dismantled the chuck and cleaned the two tapers.  Didn't see any debris and no improvement in the run out.

Obviously I'm going to call Nova tomorrow, but I have a couple of questions.  

First the run out (wobble) on the chuck is very obvious while the run out on the bit appears less pronounced.  Is that possible?

I don't have a dial indicator (this may be a reason to get one), but is there a degree of run out that is acceptable?

If I do get a dial indicator is there something special in the way of a straight rod to put in the chuck?

Posted

If you have one of those inexing rods for alligning the base plate of a router that should be pretty strait.

I'd make sure you have the chuck seated well. I remember when i got my general i had some issues with that.

Posted

Yes it is a Morse taper in the spindle and a similar shorter taper in the chuck iteself.  I have removed the the chuck from the taper and the taper from the spindle.  I've cleaned both with a rag, but discovered no debris.  I have reassembled the unit with modest taps from a wooden mallet and still have the same run out.

I'll look in my router stuff, but I don't remember any indexing pin.  I have been using a reemer I inherited.  It has some teeth at the end, but is mostly a long smooth shaft.

It occured to me last night that I have another chuck and taper I can test.  After I've had some coffee I'll give that a try.

Is it surprising that the chuck would wobble more than the bit?  Might that be an illusion?

Posted

I tried the drill chuck on my lathe and the lathe chuck on the drill.  The problem seems to be with the drill chuck.  And then I learned a valuable lesson about Morse tapers.  They're not all the same length:

20181102_102219.thumb.jpg.3ac8680f92127c74d515a6ac0e349bba.jpg

The shorter MT did not reach to the drift window in the quill.  Fortunately it was not in too tight and I was able to gently pry it out.

So I called Nova about the run out.  I was only able to leave a message.  I will follow up again later today.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 63 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,008
    Total Members
    3,644
    Most Online
    Bob44
    Newest Member
    Bob44
    Joined