Popular Post collinb Posted December 18, 2024 Popular Post Report Posted December 18, 2024 Building in place, at least for me, means inventing everything. This mantle replaces what was a concrete mantle sitting atop the bricks. As a foundation for it, I put a 2x6 across the top and attached it with construction adhesive. The mantle itself is hollow and tacked to the 2x6 on top and to the side bookshelves. The blocks was a simple cut-out with the table saw, spaced as evenly as possible. And because it as a saw cut-out I took a chisel to smooth out the back of each removed area. Behind the blocks is a support piece that they're glued to. I attached it to the top with both glue and pocket screws. The angled piece is a section of crown molding that is a piece from what will shortly go around the ceiling. It will all match. No worry about a gap between the crown base and the bricks. It's a rough brick surface so leaving a space is no issue. It has to be. Plus, since this is an outside wall, I wanted to allow for a little are movement. Attaching the crown base is in two pieces. The top edge is glued to the block support piece. And it gets extra support from some finish brads. In addition, at several points along the length I added some blocks to tack it in the middle. The crown is light-weight enough that it doesn't take much to hold it in place. 5 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.