Tpt life Posted May 24, 2025 Report Posted May 24, 2025 Who has a mini copper cutter they like? All the 1/2” cutters I have ever used, failed quickly and were awful in use. Quote
drzaius Posted May 24, 2025 Report Posted May 24, 2025 I've had a Ridgid cutter for about 50 years and it has been fine. 1 Quote
Tpt life Posted May 24, 2025 Author Report Posted May 24, 2025 On 5/24/2025 at 6:48 PM, drzaius said: I've had a Ridgid cutter for about 50 years and it has been fine. This model? Quote
Tom King Posted May 25, 2025 Report Posted May 25, 2025 I think I have three different sized models of Rigid cutters that were new in the 1970's. I can't count the number of times I've replaced the cutter wheels on them. I keep spares of the cutters. They work fine, but I don't know where they quality is since then. If you really want a top quality one, get one for HVAC tubing. I have a Hilmor and it's probably as good as they come. https://www.supplyhouse.com/Hilmor-Tools-1885384-Large-Diameter-Tubing-Cutters-1-8-to-1-3-8 1 Quote
Tom King Posted May 25, 2025 Report Posted May 25, 2025 For decades, that little Rigid was the only one that small I had ever seen for tight quarters. I expect the ones you used that didn't work good had been pushed too long on the same cutter wheel. I never paid much attention to how long the cutter wheel lasted, but it was only two or three houses worth of cutting copper pipe at the most. There is an E-clip on one side of the shaft that holds the wheel on. As long as you don't lose the E-clip, they're easy to change. 1 Quote
Tpt life Posted May 25, 2025 Author Report Posted May 25, 2025 I rarely do plumbing, but I was thinking the same thing when you mention keeping cutting wheels on hand. My big ones have gone miles of cutting beyond the minis. I wondered if that meant hardness or metallurgy is suspect on the budget hardware store cutters. I wonder if I could make a Rigid wheel go into the housings I already have. 1 Quote
Tom King Posted May 25, 2025 Report Posted May 25, 2025 The wheels are for specific models even between the different Rigid ones. If the wheel isn't a tight fit on the shaft, as in putting the wrong one on, you can end up with a nice spiral pattern around the pipe, but it won't cut the tubing worth anything. I forgot about the Lenox small one. I was in my HVAC toolbox just now and saw this one. It's a good one, but I'm not sure about the availability of replacement wheels. Fortunately, that one is Rarely used. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.