G S Haydon Posted June 28, 2013 Report Posted June 28, 2013 So I'm nearly at the end of my #4 tune up and it's time for a sharpen. I have been enjoying sharpening with my fine Norton India oilstone. However I thought I could go finer still on my refined #4. With no access to a Charnley of Arkansas stone I went and got my own. I broke a piece of an a Brazilian slate worktop that had a fault line in it with a sledge hammer. I honed the standard Record blade using some 3 in 1. I tried a lighter oil but it was too grippy. It removed the scratches quickly without too much fuss at all. I set it up in the plane with an advanced frog position and tight chipbreaker I took some long grain trial cuts in european oak with pleasing results (measured in mm). Went for and end grain cut too. I also went for some regular softwood too and different depths of cut. It all worked very well. Do any of you have any improvised sharpening methods? 2 Quote
Eric. Posted June 28, 2013 Report Posted June 28, 2013 How do you know that Brazilian slate is flat? Did you put it on a diamond plate or something? Quote
G S Haydon Posted June 28, 2013 Author Report Posted June 28, 2013 Eric it was a worktop so it was flat enough for me. These types of worktops use some quite accurate machines to make them so I only assumed flatness rather than checked it. Seemed to work OK. Quote
nateswoodworks Posted July 2, 2013 Report Posted July 2, 2013 I have used several different methods in the past but I am happiest with is what I do now. For rehabbing planes and chisels I use large sanding belts, I cut and stick them on my surfacing plate (scrap from a granite headstone manufacturer) with help from spray adhesive. Once I get to where I am content I switch to a course diamond plate, then through my oilstones. After my black surgical I go to my strop, then it's time to make shavings. For rehoning its just 2 oilstones and the strop. Quote
CessnaPilotBarry Posted July 2, 2013 Report Posted July 2, 2013 Some folks have used granite 12x12 tiles with excellent results. Look at the reflection on the top against a straightedge, you'll see how flat it is. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.