Recommended Posts

Posted

Was really very satisfied that my knowledge and skill were progressing until I flipped my stock 90 degrees. I achieved a nice finish off my Stanley No. 5 on two opposite faces of this stick. On the other two, I cannot avoid tear out on rings that seem to present like loose rather than dense end grain. A low angle block fares no better. I am practicing on this board that had a fair presentation off of a table saw so this is all just for me to get better.

post-9382-0-47398100-1378086997_thumb.jp

Here the light/yellowish is ragged fiber tear out.

post-9382-0-87910000-1378087095_thumb.jp

Here the figure planed beautifully on the surface that is up and you can see the raggedness on the neighboring side.

Posted

I believe this can be remedied by attacking the wood at a high angle. If you want to use a regular bench plane, you need to put a 25 degree back bevel on the blade(definitely want to have a spare blade for this). Or put a 50 degree micro bevel on a low angle plane.

Posted

The grain goes every which way in the Ipe I have used. You also have to be careful because I noticed it is real easy to chip out corners and edges. I ended up using my sander a lot and then it clogs up the paper if you are not careful to clean constantly with a crepe rubber block.

Beautiful results but difficult to work. Have you tried wetting it with mineral spirits before you plane?

post-6363-0-42565700-1378090776_thumb.jp

  • Like 1
Posted

Beautiful table! No I have not tried mineral spirits. I will have time to play more tomorrow. I have a spare No. 4 to play with a back bevel and can also employ spirits. Thank you both for quick responses with techniques to try.

Posted

When a normal plane doesn't work, I've had better (but not perfect) results by wetting the board first with acetone or alcohol. In really bad cases a quick coat of shellac helps even more - it 'glues' the fibres together so the blade has a better chance of cutting them.

 

If you do back bevel a blade, I'd go with a 10° to 15° bevel, giving you 55° to 60°, York pitch and Half pitch I think they're called. Haven't heard of a 25° back bevel before - that would be 70°, and I don't think it even has a name! Back beveling certainly makes a difference on hard woods, as does a high pitch bevel up blade at 50°. I haven't seen much improvement though on soft woods.

 

You don't need much bevel, even 0.5 mm to 1 mm (1/32" to 1/16") is enough.

 

If the tear out is not too deep, and you're finishing the surface, a scraper or Stanley #80 may be the right tool to use.

 

HTH

 

John

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.