Recommended Posts

Posted

I recently purchased an older craftsman miter saw on the cheap and I'd like to see if anyone could recommend a good 8 1/4" blade for it or possibly an 8 1/2" because I measured and I think it'll fit. Thanks in advance.

Posted

I want to be careful not to insult because my knowledge of old Craftsman is limited to RAS. What do you mean by "measured and think it will fit?" Is the saw spec 8.25" and you think 8.5" will fit? The one place that is tricky to measure is the bottom of the table clearance. Make sure to check this. It may not matter at .125" but I don't want you to spend a chunk of change just to hack a kerf in the table.

Posted

I understand what you're saying but there is a depth stop. But now that you mention it that extra diameter might affect bevel cuts. I think I can cut out an 8 1/2" circle from 1/8" plywood scrap mount it on the arbor and see if it'll work without touching anywhere and of it doesn't I'm only out a small piece of ply. Thanks for the concern on that!

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   2 Members, 0 Anonymous, 56 Guests (See full list)

  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined