Recommended Posts

Posted

Hey guys,

 

A while back I dropped a question about a Powr-Kraft on here and had kind of decided to give up on trying to rehab it since the iron seemed pretty whooped. Well, after reading/watching a handful of Paul Sellers videos about just this topic, I went back to it for round two. I've gotten the iron pretty darn happy. Just needs some refinement, but I'm holding off on it until I can better identify what model of plane this is, that way I can set it up in an ideal fashion.

 

I'm leaning towards this being either a smoother or a jack, but I'm not a hand tool guy, so I could be wrong on this.

 

Here are some pictures of the plane:

 

(FYI, this thing looked like it had been used as a boat anchor when I first found it. It was sitting under a pile of garbage at the bottom of an old tool cabinet. I'm pretty happy it cleaned up this well.)

 

 

photo3.jpg

 

 

It is marked Powr-Kraft on the cap and stamped Made In The USA on the body, but that's it. No other markings in or on the plane.

 

 

photo3-2.jpg

 

 

The sole is about 9.5" from toe to heel and approximately 2.5" wide.

 

 

photo1.jpg

 

 

The mouth is not adjustable.

 

The set is 45 degrees on the nose, and the blade is bevel down.

 

 

photo2.jpg

 

 

The plane body is nice and flat and straight, it has some good heft on it and once the iron was ground back and the primary bevel reset, it looks like it should be a good little work horse for the time being as I start to look into putting money aside to expand the hand tool portion of my shop.

 

I'd appreciate any input.

 

Thanks!

 

Ian.

Posted

Yes that's a smoother.  On a bench plane you don't generally have an adjustable mouth like some block planes have, you adjust the mouth by moving the frog.  Some planes have an integral frog that can't move, maybe that's what you meant, in which case it may be easier to use as a jack than a smoother. 

Posted

Excellent. Thanks for the response! And you are right, I was thinking about the frog, not the mouth, although the frog does adjust, I just had a pre-coffee brain fart.

 

Glad to hear I was on the right track. This plus my card scrapers will be a nice addition to my sanders.

 

My next addition is a quality LA block (Stanley 60 1/2 or the like). After that I'm looking at the Veritas LA Jack since it can double duty on a shooting board easily as well. That will be a nice add to the shop for cleaning up some joinery. 

Posted

Yes, this plus your scrapers will bring you lots of enjoyably quiet surfacing.  My ROS only comes out now when I have some knotty piece of wood I should have probably skipped over anyhow...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.