dwacker Posted November 4, 2014 Report Posted November 4, 2014 I could see using a shaper if I were cranking out moulding and things of that nature. I was recently at a tool auction that had 40 different shaper heads, cathedral panel templates and an old delta shaper. If you were cranking out moulding and things of that sort you would buy a moulder not a shaper. Shaper are not made for mouldings nor do they do a good job of that task although some folks will improvise a moulding now and then. Shapers are right at home with edge work and pattern work not moulding. Quote
Tom Cancelleri Posted November 5, 2014 Report Posted November 5, 2014 There's a ton of moulding cutters for shapers. Technically a rail and stile are nothing more than a moulding profile with a modified tongue and groove. Ogee, Classical, Double Ogee, etc, all moulding profiles. A shaper with a power feeder and a moulding cutter do the job as well as a spindle moulder. Essentially the same tool in theory. Quote
dwacker Posted November 5, 2014 Report Posted November 5, 2014 There is no out feed shoe for a shaper. With moulding heads you have to use makeshift out feed supports. A moulder cuts from the top like a planer. With a shaper you use a back fence and cut the mouldin off the wide stock. A shaper is not the right machine for the job. This is a real moulded knife those little 3/4 cutters should not be used for any real lengths. Quote
weithman5 Posted November 5, 2014 Report Posted November 5, 2014 So molder shaper and router all have their place 2 Quote
Janello Posted November 5, 2014 Report Posted November 5, 2014 I can cut PVC pipe with a wrap around and a sawzall, I can cut it with a chop saw, and somewhere in the PVC factory that supplies PVC pipe to the plumbing supply houses is a fully automated PVC cutter with more buttons than an f-14 fighter jet. I'm assuming, woodworking has the same privileges. 1 Quote
Tom Cancelleri Posted November 5, 2014 Report Posted November 5, 2014 I usually cut PVC with an argon laser. Quote
Janello Posted November 5, 2014 Report Posted November 5, 2014 All the hand tool guys are probably thinking....ahhhh, I can do this with a nail file. Quote
Tom Cancelleri Posted November 5, 2014 Report Posted November 5, 2014 Janello, you're absolutely correct, you make do with what tools you have on hand. It may not be the perfect tool for the job, but if it could do what you need, and give you acceptable results and be safe doing it, then by all means do it. I used to have a bench top jointer, and I'd flatten my stock on one side, and then use my 10-20 drum sander to make a parallel flat surface, not ideal, but I didn't have a planer yet. This worked for me for a while. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.