ChrisG-Canada Posted February 14, 2015 Report Posted February 14, 2015 I'm in the process of buying a Porer Cable 7518 router for exclusive mounting in a table and it was suggested to me that I replace the stock collet with a precision collet from PreciseBits.com to significantly reduce runout. It should cost me around $100 to do this. Anyone have experience with this company?In your opinion, is it necessary (or even noticeable/helpful)? Quote
estesbubba Posted February 14, 2015 Report Posted February 14, 2015 Slap a good bit in the router and make a cut. If it's smooth and no chatter I would spend the money elsewhere. 2 Quote
Tom King Posted February 14, 2015 Report Posted February 14, 2015 I have five 7518s for similar use that have run a LOT. I have worn out a couple of colletts, but they last a long time. I think the replacements I bought were 18 bucks with free shipping off ebay. I'd wear that one out first. With a good Whiteside bit, I run to finish and don't have to touch the surface. I've never had a runout issue with one. 1 Quote
wdwerker Posted February 15, 2015 Report Posted February 15, 2015 In my small pro shop a collet lasts several years minimum. Similar to Toms experience. Just buy a stock replacement when needed. 1 Quote
Tom Cancelleri Posted February 16, 2015 Report Posted February 16, 2015 Seems like an unnecessary expense. I have a 7518 in my router table and have a 1/4" and a 1/2" collet, both the stock PC, and they work great without any issue. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.