Mike Rustenbach Posted December 16, 2015 Report Posted December 16, 2015 Hey guys! I am very new to woodworking and decided to make my first project cutting boards for X-Mas. Being new, I am making lots of mistakes but at the same time learning a lot, I just see it as part of the learning curve! One thing I am running into is the wood keeps getting burn marks during rip cuts. I have a used freud 80+ tooth blade, so I am not sure if it is the sharpest or not. Should I just buy a new blade? If so, what is a good blade to purchase?I am still fairly confused as to when to use a lower tooth blade for certain operations and higher tooth blade for others. Can someone please explain this to me? Thanks again,Michael Quote
Eric. Posted December 16, 2015 Report Posted December 16, 2015 80 teeth is WAAAAY too many for rips. That's a crosscut blade for very fine cuts, essentially the blade a finish carpenter will use for thin materials like moldings.Get a new 24 tooth rip blade and try again!Ripping requires a lower tooth count and ideally flat ground teeth. For crosscuts you want a higher tooth count and ATB teeth.A lot of guys use combo blades with around 40 teeth. These blades do a decent job at everything but a great job at none.When I make cutting boards I do use a dedicated rip blade for all the ripping since I make mine with 8/4 stock of dense materials like hard maple, bubinga, purple heart. I don't love using a combo blade on materials like these, although it will work fine when it's sharp. 2 Quote
wdwerker Posted December 16, 2015 Report Posted December 16, 2015 I use a Freud glue line rip blade. But your blade needs to be parallel to the miter slot and the fence parallel too. Clean blade and a tuned up saw may be all you need. 1 Quote
wtnhighlander Posted December 16, 2015 Report Posted December 16, 2015 ^^^^ What they said. I use a 50 tooth Irwin combo, but my saw is well tuned. I still have to keep the blade very clean to avoid burn marks. A dedicated ripping blade is best. Quote
Popular Post Brendon_t Posted December 16, 2015 Popular Post Report Posted December 16, 2015 I am still fairly confused as to when to use a lower tooth blade for certain operations and higher tooth blade for others. Can someone please explain this to me? to answer your question, in a nutshell. There are 3 common tooth count/use columns.Low tooth count blades. IMO 36 &under.Best used for rip cuts aka cutting with the grain. Should not burn on rips, are capable of giving a glue ready edge. Will proabably eat your lunch if going across the grain. High tooth count blades 60 &up Used for crosscut or cuts that across or tangential to the grain. Known to burn wood on long cuts as sawdust isnt able to be carried out of the cut. Slower feed rate is preferred.Combo blades, 40-55 like a Eric mentioned above, they are capable of either cut but don't do either wonderfully. They may burn on rips and could chip out on crosscuts. These are my observations. They're are a lot of other specialty type blades for different users. Blade configuration and tooth geometry is a big subject if you feel like going deeper. 3 Quote
knotscott Posted December 17, 2015 Report Posted December 17, 2015 (edited) Tips for Picking Saw BladesBargain Saw Blade SuggestionsIn addition to choosing the right blade for the task, it's also really helpful if the stock has been dimensioned so that it's flat and straight....a planer and jointer are the best tools for that, but there other ways. Without flat straight stock as a reference point, it's difficult to get perfect joints. Edited December 17, 2015 by knotscott Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.