Gary Gilbert Posted January 25, 2016 Report Posted January 25, 2016 I have the R4512 ts and I am looking to add router table to it. Any advise. I am also waiting cause I will be getting the incra ls setup. THanks G Quote
SawDustB Posted January 26, 2016 Report Posted January 26, 2016 I added a router table in the right wing on my r4512, it was pretty easy. I went with a doubled up 1/2 inch Baltic birch, with laminate on both sides. I used the Kreg plate and levelers with it, worked great. Quote
wtnhighlander Posted January 26, 2016 Report Posted January 26, 2016 I have an older Rigid saw, and made a laminated ply router tablw insert for it. I shifted the fence rails as far as possible to the right, so I didn't give up the cast iron wing on the right, and can avoid dropping the router fir fence clearance most of the time. Works great, but almost overbalances the saw on that side. Stable when the wheels are up, but a little tippy when I roll it around. Quote
sheperd80 Posted January 26, 2016 Report Posted January 26, 2016 +1 for the Kreg Insert and Levelers. I wouldnt say theyre necessary at all, but it is a nice system. Sent from my SAMSUNG-SM-G890A using Tapatalk Quote
SawDustB Posted January 26, 2016 Report Posted January 26, 2016 Here's the thread on what I did: http://www.woodtalkonline.com/topic/19583-new-router-table-insert-in-table-saw/ 1 Quote
sj2494 Posted January 26, 2016 Report Posted January 26, 2016 I have the incra and table and router plate my only thing is the mdf table dose move when it gets realy cold out below 30 Quote
Gary Gilbert Posted January 27, 2016 Author Report Posted January 27, 2016 Thank you for the information Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.