Ewing-OK Posted July 6, 2016 Report Posted July 6, 2016 I am somewhat new to woodworking and seems like the tools that I have cannot easily do what I need. I have some 4x4 posts that I am building aquarium racks to hold several aquariums. I have built several of these before and haven't liked the raggedness of the final product. I cut a 1/2 inch notch in them to interlock shorter cross 4x4's that I bolt on (using several strong bolts) What I have used is a skill saw and made multiple cuts and then knocked out the waste, smoothing them with a chisel. I tried a router but it chattered a lot and broke bits way to fast (maybe I need a bigger/newer one that has good bearings). I tried a tablesaw but the 8 foot 4x4's were too cumbersome to handle safely. A friend suggested a sliding miter saw but they really are not set up for partial depth cuts (more an all or nothing saw or so my research tells me). In my youth I had a friend that had a radial arm saw and that seems more like what I need but they have almost vanished (and cost too much for this single job). Do the kind experts here have any advice for a grumpy old fart in backwater Oklahoma? Quote
Janello Posted July 6, 2016 Report Posted July 6, 2016 Maybe try cutting the ends of the notch with a circular saw and wasting out the middle to your line with a jig saw. You might have to flip the 4x4 to get to the middle since the blade won't likely be long enough. Drilling a hole and using a sawzall is another option. Quote
Chestnut Posted July 6, 2016 Report Posted July 6, 2016 Your circular saw method doesn't seem too terrible for large material. Is it too time consuming to cut slots with the circular saw and then clean up the whole thing with your router? I'm assuming that your trying to cut too much with your router in one pass. Quote
Ewing-OK Posted July 6, 2016 Author Report Posted July 6, 2016 The router cleanup idea I had tried, but it tended to "fall off the edge" and required more control than I could give it. The circular saw got too heavy after awhile and had similar control issues as the router. Ok, I'm a whimp, LOL. Quote
Ewing-OK Posted July 6, 2016 Author Report Posted July 6, 2016 lol The edge was side to side with a 3.5 inch drop off, the tools fall off and goudge the bottom of the notch. It is 1/2 inch deep but 3.5 by 3.5. Quote
Barron Posted July 6, 2016 Report Posted July 6, 2016 You might want to try making a wider base for your router out of plywood or plexiglass. That would help span the notch. Quote
wtnhighlander Posted July 7, 2016 Report Posted July 7, 2016 If you are doing several of these, it might pay to build a full-fledged jig to hold the router and provide "end stops" to keep the edges in line. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.