treesner Posted May 25, 2017 Report Posted May 25, 2017 Is there a router bit for putting a French cleat into solid wood. For instance a wood art piece that you just wanted to route down an area with an up cut but then add a bevel cleat to the top Sent from my iPhone using Tapatalk Quote
wtnhighlander Posted May 25, 2017 Report Posted May 25, 2017 Although cleats are usually cut on the table saw at 45*, for a light piece of art, you might get away with a dovetail bit, 7 or 8 degrees. Just make the wall cleat ro match. It will slip off much easier than a 45, but unless its in a high traffic area, nothing is likely to knock it off the wall. Quote
wdwerker Posted May 25, 2017 Report Posted May 25, 2017 A couple of little pieces of " Blue Tac" would keep it from slipping off so easy if you used a dovetail bit to cut the cleat. Quote
gee-dub Posted May 25, 2017 Report Posted May 25, 2017 Yes but, I wish it were a taller profile. Quote
Popular Post TerryMcK Posted May 25, 2017 Popular Post Report Posted May 25, 2017 https://www.trend-uk.com/en/UK/product/C197X1_2TC/3/105/bearing_guided_chamfer_angle=45_degrees.html This will do chamfers on stock 3/4" thick. More than enough for a French cleat. Use it in the router table and reference off the fence instead of the bearing. EDIT Just noticed that you want to cut a blind chamfer. That may be best tackled by fabricating the mount. Cut it on a router table using the chamfer cutter or table saw then glue it onto the workpiece. Another alternative is to cut a wide slot into the solid wood and then glue in a piece with the chamfer milled into it. 4 Quote
jimmy Posted April 14, 2020 Report Posted April 14, 2020 You could make the cabinet safe from lift-off, after you have hung it up, by sliding a strip of wood in between the cabinet and the wall, up under the wall-mounted cleat-piece, and attaching it by running screws through the cabinet's back-board. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.