lewisc Posted August 1, 2017 Report Posted August 1, 2017 Anyone had anything like this? I ran a laminated cutting board through it a few days ago. The board had been glued with TiteBond III and was drying for approximalty 12 hours before I cleaned it up. The only thing I can think of is a reaction between the metal and glue. Except for there are lines on the outside of the table where the glue line wouldn't have touched. There are no lines on the inside or outfeed table. Quote
ZombieMonkey Posted August 1, 2017 Report Posted August 1, 2017 I am going to venture to say that it is a product of the low pH of Titebond III. Not sure if more dry time or another application of whatever you are using for your metal protection would be in order. Quote
lewisc Posted August 1, 2017 Author Report Posted August 1, 2017 The only thing I've done to the table is to rub a block of beeswax across the surface. Quote
Pwk5017 Posted August 1, 2017 Report Posted August 1, 2017 How long did the cutting board sit on the table? Any chance you set it there for 30 seconds while you turned on the DC, planer, and set the height of your cut? Unprotected cast iron will stain very quickly. globs of TB contain a ton of moisture, and i can see that being enough to stain your cast iron. If it didnt sit on the table for any length of time, i am going to be really confused. I dont see those marks coming from a 2 second exposure. I once dripped a drop of sweat onto my 3 day old PM209 infeed table and didnt notice it. I went upstairs to get a drink and came back down to a big ole black dot on the table. Luckily, i wax my surface so it didnt stain the table badly, but i still have this faint black blemish on my perfect table. It does not take long, that is fore sure. 1 Quote
lewisc Posted August 2, 2017 Author Report Posted August 2, 2017 It's most likely that it sat for a few mins ( or longer, I can't remember) on the table while I did some other stuff. That makes a bit of sense especially looking at the line pattern. It's only cosmetic but still annoying to look at. I'll try to clean it up and apply a bit more wax. Quote
estesbubba Posted August 2, 2017 Report Posted August 2, 2017 Try some Wd-40 with a green scotchbrite under a finish sander. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.