Popular Post Askland09 Posted April 3, 2021 Popular Post Report Posted April 3, 2021 Finally getting a chance to use my new hand plane, and it appears to be working pretty well. 8 Quote
Askland09 Posted April 3, 2021 Author Report Posted April 3, 2021 Needs a little bit finessing yet, camber the edges and there’s a very very slight low spot in the middle Quote
Woodworking_Hobby Posted April 5, 2021 Report Posted April 5, 2021 On 4/3/2021 at 4:58 PM, Askland09 said: Needs a little bit finessing yet, camber the edges and there’s a very very slight low spot in the middle Is the a bevel up jack plane? I inherited a few old planes and I think they are smoothing planes and jack planes. Have not used them just but keeping them for when the time is right. Quote
Askland09 Posted April 5, 2021 Author Report Posted April 5, 2021 9 minutes ago, Woodworking_Hobby said: s the a bevel up jack plane? I inherited a few old planes and I think they are smoothing planes and jack planes. Have not used them just but keeping them for when the time is right. It is a low angle jack plane that I recently bought brand new. I have a couple of older planes that haven't seen or been touched for about 20+ years that I'd like to bring back into a working state. However, I wasn't sure how a good plane was supposed to work so now I have a pretty good benchmark to hopefully get them up to snuff. Quote
Popular Post Askland09 Posted April 14, 2021 Author Popular Post Report Posted April 14, 2021 Finished product! Decided since this was my first time solely using hand tools for sawing, flattening, dimensioning, jointing, etc I’d start off with something pretty easy like a cutting board. It’s nothing special, but was a nice little training exercise. 9 Quote
Mick S Posted April 15, 2021 Report Posted April 15, 2021 Consider me impressed! How did you cut the breadboard ends? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.