walnut_weasel Posted June 1, 2012 Report Posted June 1, 2012 I am finally upgrading to a cabinet saw and I would like to build a permanent outfeed table. What is approximately the minimum useful depth from the back of the saw? I don't have a lot of room, but I do have enough that I don't want a "drop leaf" style outfeed. Thanks in advance for your opinions. Quote
davestanton Posted June 1, 2012 Report Posted June 1, 2012 Try to have a little more than four feet behind the riving knife. 1 Quote
Southwood Posted June 1, 2012 Report Posted June 1, 2012 Yep, 48" is about right for me as well. Quote
rmac Posted June 1, 2012 Report Posted June 1, 2012 Try to have a little more than four feet behind the riving knife. Exactly. That lets you rip an eight foot board without having it want to tip over the back of the outfeed table at the end of the cut. If you're planning to cut even longer boards, then the answer is "a little more than half the length of the longest board you want to rip." -- Russ Quote
Beechwood Chip Posted June 1, 2012 Report Posted June 1, 2012 On the rare occasions when you want to rip something longer than 8', you can use a roller stand or something. No need to tie up that shop space for a "what if". Now, if you know that you'll be ripping longer boards often, then size your outfeed accordingly. 1 Quote
Wayniackc Posted June 3, 2012 Report Posted June 3, 2012 I made mine less than required for 4ft of support, but then if I am ripping a full sheet I can just turn the table lengthwise and it works just as well. 1 Quote
walnut_weasel Posted June 3, 2012 Author Report Posted June 3, 2012 Using the full 4' will bring one corner of the table a little too close to my bench. Turning the table lengthwise on occasion is a great idea! Thanks fellas. Quote
Eric. Posted June 3, 2012 Report Posted June 3, 2012 On the rare occasions when you want to rip something longer than 8', you can use a roller stand or something. No need to tie up that shop space for a "what if". Now, if you know that you'll be ripping longer boards often, then size your outfeed accordingly. That's what I do, too. My space limited my outfeed table size to about 44" in depth, so I just stick a roller back there when ripping full sheets. Woulda been nice to have that extra 4-5", but not the end of the world. The bigger the better, though, for sure. Quote
Trip Posted June 3, 2012 Report Posted June 3, 2012 ==> but then if I am ripping a full sheet I can just turn the table lengthwise and it works just as well funny, i never thought of that... Try to keep the outfeed as long as you can... i went from 30" to 48" and i just felt my operations were 'safer'... It may have been an allusion, but the feeling persists.... there is something nice about ripping stock to about 52" and have it entirely rest on the outfeed side.. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.