ScoFF Posted September 9, 2012 Report Posted September 9, 2012 Sometimes when I plane end grain, usually with my block plane I get a loud squeak as it moves across the wood, let's say oak. My plane is a Veritas and pretty sharp, not waxed and it cuts fairly well, anyone else get this? Quote
TRBaker Posted September 9, 2012 Report Posted September 9, 2012 Bob, I've never experienced this. Maybe your plane is too clean. Quote
wleingang Posted September 9, 2012 Report Posted September 9, 2012 Happens to me all the time too. And I generally try to avoid it because it's so annoying and my shavings are pathetic. I've always wondered why. Quote
nateswoodworks Posted September 9, 2012 Report Posted September 9, 2012 I don't get squeeking but I also alway use paraffin wax, could be the difference? When the wax is running thin I do start to get a somewhat loud rubbing noise, maybe the squeaking would come if I kept going without rewaxing? What angle is your iron sharpened to and how does the finished cut look? I keep my blockplane that I use for endgrain at about 35 degrees, my bed angle is about 12 and I hone to about 20 and add the secondary and tertiary add about another 3 degrees-many different ways to do it this is just what I have found that works for me. I don't plane endgrain unless my iron is razor sharp, any duller and it starts to tear fibers instead of slicing. I would try some wax, hone your iron as sharp as you can, and then skew your blockplane as you plane as that will reduce the angle a little more giving a better cut without making the honed point of the iron too weak. You probably already knew this and is way more than you wanted to know but I got rambling and I'll be danged if I am deleting my typing:) Quote
rodger. Posted September 9, 2012 Report Posted September 9, 2012 +1 for paraffin wax. I use it on my planes and saws. Works great! Quote
Bob Rozaieski Posted September 9, 2012 Report Posted September 9, 2012 You have a piece at the far end that is chipped but still hanging on and it is vibrating when the plane passes over it. To avoid this, don't plane off the end but instead plane toward the middle from both ends. Quote
ScoFF Posted September 10, 2012 Author Report Posted September 10, 2012 I have a bed angle of 12 degrees and 25 degree bevel on my blade, I likely have a microbevel too. It is possible about the trailing end grain tearout causing the rubbing, I'll chamfer that end off before trimming the end grain from the opposite (starting) end and report back. I usually have to go at an angle to make it slice better. Quote
RenaissanceWW Posted September 11, 2012 Report Posted September 11, 2012 I have experienced this but it was caused by vibration. Either too much of the board was exposed above the vise or it was not held tight enough. It can also occur if you are trying to take too thick a shaving. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.