Recommended Posts

Posted

I just bought the veritas jointer, bench plane and smoother plane. The guide that came with them sayes to use a 25 degree angle when sharpening. And to use a micro bevel. I am using the Veritas angle guage. So the angle is correct

Here is the problem when I follow ther directions. I change the plane iron angle all to gether. Does this alway happen? Any sugestion on how to keep the factory angle. And if i change the angle will it mess up the plane?

Posted

I color the edge with a sharpie. Set the angle by eye and take a light pass, look at the darkened edge to see if you are dead one or need to adjust. If only the cutting edge is scraped lower it, if only the heel is scraped raise it.

The angle doesn't have to be perfectly the same as the factory, close is good enough.

Posted

Also since it came from Veritas I would only worry about honing the micro bevels. Basically the 25 degrees is the factory sharpened bevel, then raise your angle a degree or two and sharpen on your fine stone, raise a degree or so and sharpen on your finest stone. Some people only put one micro bevel on using their finest stone, the choice is yours. I go with two micro bevels because for me it's quicker and it seems to me like the results are better. The nice thing about micro bevels is that the material you remove is small and easy to redo making experimenting easy.

Posted

These days I rarely pay attention to the actual bevel angle since my honing is all done by hand. That being said, changing the angle is nothing to worry about (within reason). I also agree with Nate that there is really no reason to mess with the angle Veritas provides and just go right on to the micro bevel.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.