Jeremy German Posted May 7, 2013 Report Posted May 7, 2013 I'm sold on getting the 1.75hp Sawstop cabinet model. However there are three options: 30" fence, 36" fence, 56" fence. I'm guessing that's the length of the rails that the fence rides along and will determine the max capacity I have when cutting? I don't want to lock myself out doing certain things but I also don't want to pay for the 56" fence system (in money and space) if I don't think I need it. Anything else I should consider when choosing the saw? I'm probably going to order the mobile base as well and hold off on the over the table dust collection until later. Quote
wdwerker Posted May 7, 2013 Report Posted May 7, 2013 Unless you plan to work with a lot of sheet goods the 36" fence will do fine. Build an outfeed table to catch parts as they come off the back of the saw. Quote
Mike M Posted May 7, 2013 Report Posted May 7, 2013 The 52" rails are nice because they let you slide the fence out of the way when you need space to the right of the blade. They do take up more shop space so that is the tradeoff. Cutting sheet goods is about the only reason I could imagine using the capacity and then only if I had lots of support tables around the saw. In all my years of woodworking, I have never had the need to rip more than 36" width. Quote
Jeremy German Posted May 7, 2013 Author Report Posted May 7, 2013 Thanks guys. I have a track saw if I need to break down large sheets. I think I'll make sure the bench I'm building is the same height as the saw for outfeed. I need to go take measurements of my garage and figure out how the heck I'm going to arrange all of this stuff. Quote
Levi Rathje Posted May 7, 2013 Report Posted May 7, 2013 If you plan on cross cutting long pieces on there on a cross cut sled the shorter rails will hinder it and you will have to take the fence off. I have 30" and have to take it off to cut wide lumber I can't cot on the miter saw. Quote
lildesertwoodshop Posted May 7, 2013 Report Posted May 7, 2013 If your space is limited like my shop / my 3 car garage and moving your saw will come into play, give some thought to the level or un-levelness of the floor. I built an out feed table for my saw in its normal position however when I move it to is alternative spot my garage floor is pitched like many and the out feed table was an 1" off one edge and 1x1/2 " on the other edge. To remedy this I put some elevator bolts on the legs of the out-feed table. I also have a work bench on wheels that moves around a lot , its heavy and the elevator bolt thing is to wimpy for this so to keep it level I got 4 trailer crank up jack stands , no wheel just foot plates, and in a few cranks here and there it is level wherever I park it Quote
Tpt life Posted May 7, 2013 Report Posted May 7, 2013 I have seen a lot and the trailer jack is genius. They are well equipped to handle the weight. Good thinking! Quote
knotscott Posted May 7, 2013 Report Posted May 7, 2013 AFAIK, the 36" and 52" are a step up from the 30", so you might want to spring for the upgrade even if it's only the 36". 36" 30" Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.