Bombarde16 Posted August 19, 2013 Author Report Posted August 19, 2013 OK, the procrastination ends here. The ends of the bell castings are cradled in half circle recesses with a notch cut out for the clapper. Here's a shot of the existing cradles: Thirty bells, all gradated in size and all needing half circles with an accuracy of +/- 1/16". This is a job for an adjustable circle cutter And a piece of plywood to check the fit. I did this for the first few bells: Cut a circle in the scrap, check for fit and then cut the actual stock. Once I had done a few, I could simply measure the next bell against the previous hole and eyeball the amount to adjust the cutter. The circle cutter benefits from sharpening from time to time. Good time to highlight how good it is to practice the muscle memory for freehand sharpening. Find the bevel angle, lock your hands and go; there isn't a sharpening jig on earth that would help you with this. Quote
Bombarde16 Posted August 24, 2013 Author Report Posted August 24, 2013 And there it is. Thirty different recesses roughed out using a circle cutter, a and a crosscut sled. Some sanding and a little upholstery yet to go, reaching the home stretch. Quote
Bombarde16 Posted August 26, 2013 Author Report Posted August 26, 2013 Shellacked the racks and felted the circles. Last order of business will be to make a set of shelves in the center to hold the handles. Quote
Bombarde16 Posted September 9, 2013 Author Report Posted September 9, 2013 Ugh. I still haven't gotten this one out the door yet. Getting close. All the felt is roughly glued in and the holes are all predrilled. Once this dries, I can slice the excess and start wrapping this up. Quote
Bombarde16 Posted September 10, 2013 Author Report Posted September 10, 2013 Finally finished and ready to be presented at church on Sunday. It's a good thing I'm not a professional: I badly underestimated the time I needed to make all the internal cradles for the bells and would have lost a fortune on this build. Beyond that, what else can I say about this project: I now understand why people tend to fall in love with fumed white oak...it is off-the-charts gorgeous. But it's a ironclad bastard to work and I'm hoping my next project will involve softer wood. I'm getting faster and more accurate at mortising for hardware such as hinges and locks. Grain matching and, specifically, being able to get all four sides of a box from a single board with the grain wrapping all the way around remains an enormous point of value for me. Thanks for following along. Quote
Freddie Posted September 10, 2013 Report Posted September 10, 2013 You do very beautiful nice work Rob, and how much you wanna bet I am slower!! Quote
G S Haydon Posted September 10, 2013 Report Posted September 10, 2013 I'm sure the church will be delighted. Good work Rob! Quote
wdwerker Posted September 12, 2013 Report Posted September 12, 2013 Excellent work! You are a very talented craftsman. I really like the 2 tone look on the front of the middle box. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.