David Monette Posted February 23, 2014 Report Posted February 23, 2014 Well, after countless hours of reading here on the forum and many, many You Tube videos, I finally decided on a block plane - I ordered the Lie Nielsen Standard Type : No. 60-1/2 Low Angle Adjustable Mouth. Can't wait to get it! I know this might cause allot of consternation, but I am the only one who has to use it...just saying. 1 Quote
Llama Posted February 23, 2014 Report Posted February 23, 2014 I love everything LN! I have the small bronze block, and I love it! I actually don't have the one you listed, but it is on the list. Quote
wdwerker Posted February 23, 2014 Report Posted February 23, 2014 I am sure you will enjoy it. I got a similar one from Lee Valley that I have been very happy with. Quote
David Monette Posted February 23, 2014 Author Report Posted February 23, 2014 I will post a pic when it arrives... Quote
Eric. Posted February 23, 2014 Report Posted February 23, 2014 I have one. It's a fantastic tool of course. I prefer the standard angle for most jobs but the low angle is good for end grain...flushing plugs and dovetails and stuff. Quote
Freddie Posted February 23, 2014 Report Posted February 23, 2014 Buy an extra blade for the 60 1/2 and you have both planes in one eric. Quote
Eric. Posted February 23, 2014 Report Posted February 23, 2014 Yep, and you gotta change the blade all the time. Quote
TerryMcK Posted February 23, 2014 Report Posted February 23, 2014 Enjoy . I have the small bronze 103 and it's fabulous. Quote
Freddie Posted February 23, 2014 Report Posted February 23, 2014 Life is tough, but will that really slow down your workflow eric Quote
David Monette Posted February 23, 2014 Author Report Posted February 23, 2014 So the low angle 60-1/2 comes with a 12 degree blade and the 9-1/2 it has a 20 degree blade? So in effect to have both planes all I need is the 20 degree blade for the same plane? Is that the only difference? Quote
Tpt life Posted February 23, 2014 Report Posted February 23, 2014 I am not a LN expert, but in the Stanley number equivalents the angles you reference are bed angles and not bevel grinds. Quote
David Monette Posted February 24, 2014 Author Report Posted February 24, 2014 That makes sense - what makes it a low angle plane is the bed angle casting and not the blade type, angle or position... Quote
Freddie Posted February 24, 2014 Report Posted February 24, 2014 Low angle is 12 degree bed and standard is 20 degrees. The low angle bed will allow you to cut end grain and take light long grain cuts. Thats more than enough efficiency for my block plane needs. With your iron at a primary bevel of 25 degrees, the low angle bed will give you a 37 degree cutting edge. The 20 degree bed will give you a 45 degree cut. In a low angle bed block plane, if you put a 35 degree microbevel on your iron, you would essentially set your cutting angle up to take standard long grain cuts. I personally have mine polished at the 25 degree primary bevel. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.