Recommended Posts

Posted
I decided to take a short break from the chair build - it had been quite intense for a while and it was time to chill out for a couple of weeks. 
 
The background to this bench is that each year I get invited to demonstrate something at the Perth LN Tool Event - joint making, dovetailing, tool building, whatever. And each year it is held I wind up with a bench that suits a power tool user! One small face vice that is inaccessible, and a large flat bench without dogs. I can use clamps only, and this is not really convenient when planing mouldings, rebates, grooves, sliding dovetails, and so on. I have a Moxon vise, but what I really need is a bench. So I decided to build a small bench that I could fit in the car (I have a two-seater so it has to be small). 
 
This is what I came up with with scraps on hand: 28" long, 15" wide, and 2 1/2" thick. Materials were Pine sandwiching a LVL core, and Jarrah for the central dog holes, wagon vise and screw.
 
Bench1_zps46448cec.jpg
 
Bench2_zpsb95b15f4.jpg
 
Bench3_zps78f2b459.jpg
 
I agree with Chris Schwarz, who recently blogged on cutting full blind dovetails, and wrote that the through dovetail is the most difficult of all to get right. Particularly when the tail is 1 5/8" long.
 
Bench8_zps495b431f.jpg
 
What I love about the brass Veritas dogs is that they are spring-loaded. They compress into the dog hole, and then pop up at a touch of the finger ..
 
Bench4_zpscfef100f.jpg
 
The dogs can be re-sited for traversing ...
 
Bench5_zpsadd18ecf.jpg
 
... and they may also be used with the Veritas Surface Clamp, which is the only hold down with a leg short enough for this bench ..
 
Bench6_zps6b1ecbb6.jpg
 
The end of the bench has an adjustable planing stop.
 
Bench7_zpsc6bccee8.jpg
 
The black dots (above) are where I shall drill holes to clamp the bench down on the "table" top.
 
The screw for the wagon vise was intended to be made with a kit, but it did not work (blunt blade which did not work after I sharpened it), so I turned the threads on a power router and finished with a file ..
 
Bench9_zps768e33ac.jpg
 
Here are the parts ..
 
Bench10_zps517a78f4.jpg
 
.. and together ...
 
 
Regards from Perth
 
Derek
  • Like 2

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.