Skip to content
View in the app

A better way to browse. Learn more.

Woodworking Forums & Project Advice | Wood Talk Online

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Mortise and tenon

Featured Replies

Okay I'm new to the forum and I'm a novice at this. I want to try to make a small table using the mortise tenon method. How deep do you want to make mortise if you using a leg is 1 3/4"x1 3/4". Should I drill 13/16" deep? The next cut on the next side witch is just 90 degrees away, will it interfere with the first mortise?

Sent from my iPhone using Tapatalk

i believe the general rule is little over half way that way the far side is not too weak to stress.  i haven done many mortise and tenon and when i did i messed them up. 

On a table leg when two mortise's converge I would put a 45 deg. miter cut on the converging tenons that way you have maximum penetration in the leg mortise's by both tenons. That's the way I've approached apron to leg connections on the tables I've built in the past.

Another way to cut tenons which intersect inside their motices is to cut opposing 'haunches' on each tenon, one on the top half, the other on the bottom. That way they overlap inside the mortice. I doubt it any stronger than mitering the tenons, but might be more convenient to cut.

Part of the answer to the question depends on how much of a reveal you're going to have in front of the aprons on the leg.  If you're mortising dead center on the legs then going half the depth of the leg is going to have the tenons interfering with one another and you'll have to use one of the methods discussed above to have them meet in the middle.

 

However, the more typical approach to mortising in an apron on a leg is to have it closer to the front of the leg.  With a 1.75" wide leg you might try having just .25" between the apron and the front of the leg.  If your aprons are the typical .75" thick then that would leave .75" behind the apron on the leg.  You could then make your tenons a full .75" long and they should just miss one another.

 

Oh, and the answer to the tenon length is typically half the width of the leg.  You want as long a tenon as possible without compromising the strength of the leg.

  • Author

You guys have all given great advise. This really helps tremendously. Thank you. I'm probably going to go get my materials later this week I can't wait to get started.

Sent from my iPhone using Tapatalk

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Who's Online (See full list)

Forum Statistics

  • Total Topics 32.1k
  • Total Posts 437.6k

Member Statistics

  • 26,012 Total Members
  • 3,644 Most Online
  • JAR Newest Member ·

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.