Recommended Posts

Posted
5 hours ago, wtnhighlander said:

Nice looking frames, Matt! Mind sharing your technique for V-grooving the miters?

Shallow chamfer on all the miters prior to glue up. I do it with really shallow bites on a climb cut to avoid blowing out the end of the miter. Typically I just use an indexing pin and have never felt like it was out of control in the slightest. Though, a coping sled would probably be the technically safer option.

4 hours ago, vinnyjojo said:

Pretty frames. Tough to tell, but it's not framed cross grain right? Looks like the maple might be edge to long maybe?

Sent from my iPhone using Tapatalk

The maple edge is in fact glue edge to long grain. I went back and forth on this but I've done it in the past and never had any issue. That edging is very thin and the frame itself is actually fairly thin as well. I did some calculations and the movement should be nearly nil. That combined with past frames lead me to believe that it should be alright. Though of course if it was any sort of more regular/larger edge banding I would certainly avoid the cross edge to long grain glue bond.

Thanks for the comments guys!

 

4 hours ago, vinnyjojo said:

Pretty frames. Tough to tell, but it's not framed cross grain right? Looks like the maple might be edge to long maybe?

Sent from my iPhone using Tapatalk

Oooooh you meant the birdseye one I bet. My bad. Yeah that one made me think for a while about how I wanted to tackle it. I ended up joining the pieces with dominos and cut the slots oversized and only glued the middle one. Kinda like how I'd do it for a breadboard end. Its a bit of an experiment to see if it will allow enough movement. If it fails, oh well, I'll make a new one for them. But the pieces are pretty thin (2") so the movement should be fairly minimal. Fingers crossed.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Who's Online   0 Members, 0 Anonymous, 56 Guests (See full list)

    • There are no registered users currently online
  • Forum Statistics

    32.1k
    Total Topics
    437.6k
    Total Posts
  • Member Statistics

    26,009
    Total Members
    3,644
    Most Online
    Joseph b
    Newest Member
    Joseph b
    Joined