Recommended Posts

Posted

I have a Dewalt 735 and I find that often I'll have boards that I need to be planed to the same thickness, but they don't always start off the same.  In several cases, I have the correct height, but then I need to adjust it higher in order for the next board to fit in, then re-adjust back to the final height.  It's a bit difficult to get it always exactly right.  Any suggestions on how to ensure that when I need to change the height, I can then re-adjust again back to the final depth?

Thank you!

Posted

 I think we all deal with this to some extent. I select the thickest Board and adjust my planner for that.  Once that board is as thick as the next thickest  board, I run them both through until they are a thick as the next thinnest and so on until I reach the thickness I am targeting for all boards.

  • Like 1
Posted
4 minutes ago, gee-dub said:

 I think we all deal with this to some extent. I select the thickest Board and adjust my planner for that.  Once that board is as thick as the next thickest  board, I run them both through until they are a thick as the next thinnest and so on until I reach the thickness I am targeting for all boards.

This is what I do also.  I have an area next to my planer where I stack what I am working on and stack them thinest on the bottom, thickest on top so I don't mix them up.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.