Denette Posted December 6, 2017 Author Report Posted December 6, 2017 Just got word that my replacement has arrived today - nice going, Amazon customer service! The old one only got picked up yesterday, and the day before that was when I requested the replacement. 1 Quote
Jfitz Posted December 6, 2017 Report Posted December 6, 2017 excellent! hope the new one works out better.... Quote
Chet Posted December 6, 2017 Report Posted December 6, 2017 Well lets get that baby set up and see if it is in better shape. Quote
Popular Post Denette Posted December 7, 2017 Author Popular Post Report Posted December 7, 2017 Oh, yeah! This one is in perfect condition. Everything is square, flat, and in order as it should be. Now all that I have to wait for is my set of Powermatic bits and I’ll be set for life when it comes to mortises. 4 Quote
Denette Posted December 8, 2017 Author Report Posted December 8, 2017 WOW. My Powermatic hollow chisel mortising bits (4 sizes from ¼" to ½" for $200) were delivered yesterday. They are immaculate. You definitely get what you pay for. I spent more than I wanted to on this tool, but it will serve me well for years. I had tried to buy some cheaper chisels with the intent of picking up the Powermatic ones later on, but the cheaper ones I bought were of such poor quality that I couldn't even sharpen them, much less use them. Meanwhile, the PM mortising bits arrived sharp enough to shave with. You get what you pay for. Quote
Tom King Posted December 8, 2017 Report Posted December 8, 2017 Make sure the bit seats all the way home in the chuck, and leaves a little clearance below the cutting edges of the chisel. If you just allow friction to hold the bit in place, at some point it will get pushed up into the chisel. They may be made exactly correctly for that mortiser, but it would surprise me. To accomplish this, i have stacked small washers on the end of the bit, superglued in place on the bit shank only. Common procedure is to put a dime under the shoulder of the chisel, clamp it in place, and then push the bit up until it just touches the chisel. This is where the little washers come into play. You want it to seat all the way in the chuck, and almost touch the chisel. Once the bit is good, take the dime out, and push the chisel all the way up. This way, anytime you use that setup again, it's ready to go with no more fiddling with it. The Japanese Star brand chisel and bits come with long drill shanks, and some cutting is required for some mortisers. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.